Digital Temperature Controller.

1.5 HP Motor.

Pneumatic Lid.

3 Phase.

Hopper Dimensions:  20″L x 46″W x 20″H.

Batch Style with Auger.

How it works:

A batch of sludge is dumped into the dryer.

After closing the cover, heat (electric) is indirectly applied, drying off moisture.

Rotating auger screws mix the sludge for maximum moisture release and uniform consistency.

Granular material is discharged when the batch is dry.

All wetted Parts are Stainless Steel, Auto Temp Control.

Tested.

Stainless Steel Belt with High Temperature Bearings.

400,000 BTU’s /HR. Up to 190 lbs./hr. water removal rate.

20 Cu’ Steel Load Hopper.

Stainless Steel Fume Scrubber.

Water removal rate from 45 to 190 lbs. per hour in high volume applications and removes 7 to 50 lbs. of moisture per hour in low heat, low volume situations.

Tested

Refurbished. Includes fume scrubber and all new gas burners. Stainless steel hopper.  Water removal rate from 45 to 190 lbs. per hour in high volume applications and removes 7 to 50 lbs. of moisture per hour in low heat, low volume situations. Tested

Sold as-is.  Missing blower for fume scrubber.  4 Cu' Per Hour.  Variable Speed.  Fume Scrubber.   Steel Construction with Stainless Steel Auger.  925 Degree Operating Temperature.  Digital Controls.  Hopper Dimensions:  68"L x 50"W x 85"H.  Chamber Dimensions:  138"L x  52"W  x 95"H.

Stainless Steel Hopper. Stainless Steel Belt. Stainless Steel Fume Scrubber. High Temperature Bearings. 94 lb. Per Hour Water Removal Rate. Fully Refurbished. Tested

Approximately 94 lbs./hour water removal rate. New high temperature bearings on conveyor. Stainless steel fume scrubber. Stainless steel hopper. Stainless steel belt. 240/480 volts. Fully refurbished. Tested.

Refurbished.

Includes stainless steel fume scrubber stainless steel hopper.

Water removal rate from 45 to 190 lbs. per hour in high volume applications and removes 7 to 50 lbs. of moisture per hour in low heat, low volume situations.

Hydraulic Dumping Mechanism for Dump Hoppers.

Tested.

Batch steam heat sludge dryer with fume scrubber.

3-6 Hour Dry Time.

Inner Dimensions:  36″L x 24″W x 20″H

Dryer needs to be connected to a steam source.

3 Cu’ Capacity

Tested.

Sold As-is. Sold fully refurbished for $29,500. Nominal Throughput: .75 – 1.5 cubic feet (removes a maximum of 47 lb water/hour, based on using 2125 BTU to remove 1 lb of water) BTU requirement may vary w/ materials. Heater Output: 125,000 BTU maximum.    Natural Gas Requirement:125 CFH at 7″ W.C. minimum to 28″ W.C. Maximum.  Steel hopper and stainless steel fume scrubber.  3 Phase.  Weight: 3000 lb empty.

Approximately 94 lbs. Per Hour Water Removal Rate. New High Temperature Bearings on Conveyor. Stainless Steel Fume Scrubber. Stainless Steel Hopper. Stainless Steel Belt. 240/480 Volts. Fully Refurbished. Tested.